Supplies
- 2 Feet of leather cord
- 1 1/2 feet rolo chain
- 1 large jump ring
- 1 large holed bead
Directions
Step 1
Cut chain into two equal pieces
Step 2
Lay pieces of chain down parallel to one another and pin down to secure the
two pieces. (a velvet board works well for this)
Step 3
Take your piece of leather and thread it through the first links in both pieces
of chain. (The links should be standing up, not lying flat)
Step 4
Take both ends of the leather and thread them through the third set of links
skipping the second set but going around them. (think of like lacing up shoes.
Step 5
Continue this process until you have finished. You should be at the end of the
chain bus still have cord left over.
Step 6
Attach a large jump ring to the two links that you started with.
Step 7
On the side with the leftover leather, thread both pieces of leather through a
large holed bead (we used a ‘Pandora’ style bead) then through the large jump
ring which you attached in the last step, and then back through the bead.
Step 8
Tie a knot at the end of each piece of leather.
Step 9
Wear and love your new bracelet!